Why seasonal maintenance is essential in Quebec
Your doors and windows face some of the harshest conditions in the world: winters at -30°C, humid summers at 35°C, freezing rain, wind and intense UV rays. Without regular maintenance adapted to each season, their lifespan can be shortened by 5 to 10 years. Here is a complete calendar to keep your openings in perfect shape all year long.
Spring (April–May): the big clean-up
Deep cleaning
- Wash the glass inside and out with a solution of warm water and white vinegar. Avoid abrasive products, which scratch the glass.
- Clean the frames in vinyl or aluminum with mild soapy water. For wood frames, use a cleaner made specifically for wood.
- Clear the sliding tracks of your patio doors and sliding windows. Build-up of dirt, de-icing sand and debris is the number one cause of jamming.
- Clean the drainage holes at the bottom of the frames with a small wire or a pipe cleaner. These holes let water drain out, and blocking them causes infiltration.
Post-winter inspection
- Check the condition of the exterior caulking. Winter may have caused cracks or lifting.
- Inspect the weatherstripping for wear, crushing or tearing.
- Examine the sealed units for any sign of fog between the panes.
- Test the operation of all handles, locks and opening mechanisms.
Summer (June–August): lubrication and protection
Lubricating the mechanisms
Summer is the ideal time to lubricate all the hardware on your doors and windows:
- Hinges and pivots: apply a few drops of silicone lubricant (never WD-40, which attracts dust).
- Locking mechanisms: lubricate locks with a dry graphite lubricant.
- Sliding tracks: clean them, then apply a silicone spray lubricant to the tracks of your patio doors and sliding windows.
- Espagnolettes and stays: lubricate the pivot points of tilt-and-turn windows.
Checking the screens
Inspect your screens: torn mesh, bent frame, faulty retention system. A damaged screen doesn't just fail to keep insects out — it also contributes to your home's natural ventilation in summer.
UV protection
If you have wood frames, check the condition of the varnish or paint. The intense UV of a Quebec summer quickly degrades finishes. Refreshing the protection in early summer will add several years to the life of your frames.
Fall (September–October): getting ready for winter
Caulking and air tightness
Fall is the critical time for air tightness:
- Inspect all the caulking around every door and window. Immediately replace any joint that is cracked, lifting or missing.
- Replace worn weatherstripping. According to Hydro-Québec, air leaks and ventilation can account for up to 25% of a home's heat loss.
- Check the threshold of exterior doors. The gap between the threshold and the bottom of the door should not let daylight through.
Preventive replacement of failing thermos units
If you have spotted sealed units showing signs of fogging or loss of insulation, don't wait until winter to replace them. Thermos (sealed glass unit) replacement is ideally planned as early as the end of summer: manufacturing generally takes 2 to 3 weeks, and fall is the busiest period.
Seasonal changeover
- Remove the screens and store them properly.
- Install storm windows if your home has them.
- Make sure all windows close and lock properly.
Winter (November–March): monitoring and humidity management
Managing condensation
Condensation on windows is the number one problem in winter:
- Keep relative humidity between 30% and 40% when the outside temperature drops below -10°C.
- Use a hygrometer to monitor the humidity level in your home.
- Run the bathroom fans and the kitchen range hood systematically to evacuate excess humidity.
- Keep heat registers clear under the windows so warm air can circulate along the glass.
Watching for ice
- Never scrape ice off the glass with a metal tool — you risk scratching it.
- If ice forms between the panes, that's a sign the thermos has failed and must be replaced.
- Watch for ice build-up on door thresholds and clear it regularly to avoid damaging the weatherstripping.
The 5 essential tasks of the year
To make things easier, here are the 5 essential tasks to do each year:
- 1. Clean the glass, frames, tracks and drainage holes (spring).
- 2. Lubricate all the hardware (summer).
- 3. Caulk and replace the weatherstripping (fall).
- 4. Inspect the thermos units for fogging (spring and fall).
- 5. Control humidity and condensation (winter).
By following this maintenance calendar, you'll add several years to the life of your doors and windows and avoid costly repairs. If you notice a problem during your inspections, Vosthermos offers a full range of services: from thermos replacement to professional caulking. Check out our pricing or visit our shop to see our products.

